Hendi 210000 Mode D'emploi page 11

Instructions for use
Position the appliance so that the on/off switch is facing the user.
•
If the blade sharpener has not been installed, proceed as follows:
•
Position the blade sharpener in its support so that the blade does not extend between the
o
gears.
Tighten the safety screw on the blade sharpener.
o
Turn the appliance off (the appliance is equipped with a safety switch and will turn off
•
automatically if the sharpening device is removed)
Push the plug in the wall socket.
•
Turn the dial with the graduated scale to the desired slice thickness.
•
Switch on the appliance using the on/off switch. The blade will start to turn.
•
Put the food product on the carriage and adjust the clamp to hold the product firmly in place.
•
Make sure the product is positioned against the stop plate.
Once the product has been sliced, switch off the appliance with the on/off switch. The blade will
•
stop turning.
Turn the thickness dial back to 0.
•
Cleaning and maintenance
• Turn the slice thickness dial in counterclockwise direction to the "0" position,
• Always pull the plug from the socket before cleaning the appliance.
• Warning: Never submerge the appliance in water or other liquids!
• Use a damp cloth to clean surfaces (solution of water and a mild cleaning agent).
• Never use corrosive or abrasive cleaning agents. Do not use sharp or pointed objects for
cleaning. Do not use benzene or solvents! Clean with a damp cloth. Use washing-up liquid if
needed, but never abrasive cleaning agents.
•
Clean the blade with alcohol. WARNING! The blade is extremely sharp.
If the food carriage stops sliding smoothly, lay the machine on its side. Clean the slide bar
•
carefully and lubricate it with Vaseline