Hendi 210000 Mode D'emploi page 10

Preparations before using for the first time Preparations before using for the first time
• Check to make sure no parts are missing. If any parts are missing, contact your Check to make sure no parts are missing. If any parts are missing, contact your supplier. Check to make sure no parts are missing. If any parts are missing, contact your
• Remove all the packing material. Remove all the packing material.
• Clean the appliance with lukewarm water and a soft cloth. Clean the appliance with lukewarm water and a soft cloth.
• Clean the blade. Be careful: the blade is very sharp. Clean the blade. Be careful: the blade is very sharp.
If the sharpening device is not attached, proceed as follows: If the sharpening device is not attached, proceed as follows:
•
• Attach the supplied feet to the appliance.
•
Attach the hand guard.
NOTE! You are advised not to use the appliance if the feet and hand guard are not attached as You are advised not to use the appliance if the feet and hand guard are not attached as You are advised not to use the appliance if the feet and hand guard are not attached as
•
instructed! These are safety features that will prevent possible injury. If you do not attach these instructed! These are safety features that will prevent possible injury.
features, there will be a risk of injury. features, there will be a risk of injury.
• Keep open a space of at least 10 cm around the appliance to allow for adequate ventilation. Keep open a space of at least 10 cm around the appliance to allow for adequate ventilation. Keep open a space of at least 10 cm around the appliance to allow for adequate ventilation.
• Position the appliance in such a way that the plug is always accessible. Position the appliance in such a way that the plug is always accessible.
1
Top view of the Top view of the
appliance appliance
2
Attach the Attach the
sharpening module sharpening module in
such a way that the such a way that the
blade does not move blade does not move
between the wheels. between the wheels.
appliance.
1
The appliance has The appliance has
holes on the bottom holes on the bottom
for the feet. for the feet.
1
Place both screws in Place both screws in
the carriage. the carriage.
2
Attach the hand Attach the hand
guard.
NOTE! The sharpening device is equipped NOTE! The sharpening device is equipped
with a safety switch. If the sharpening device with a safety switch. If the sharpening device
is not properly attached, you will not be able is not properly attached, you will not be able
to use the appliance. to use the appliance.
3
Secure the sharpening Secure the sharpening
device to the machine device to the machine
by tightening the holder. by tightening the holder.
Check to make sure that Check to make sure that
the sharpening device is the sharpening device is
well secured before well secured before
using the machine. using the machine.
2
Insert the feet and level Insert the feet and level
the appliance (with a the appliance (with a
spirit level). spirit level).
3
Place the two washers Place the two washers
over the bolts. over the bolts.
4
Screw on the two dome Screw on the two dome
nuts. nuts.
If you do not attach these