Niko 10-824-01 Mode D'emploi page 9

10-824-01
Read the complete manual before attempting installation and activating the
system.
1. DESCRIPTION
Video splitter 10-824-01 is used for the distribution of the video signal within a star-cabled
system (fig.1). The video splitter receives the video signal and splits it up in two separate
video output signals. After splitting, every video signal can be amplified separately. You are
recommended to place the video splitter at the beginning of a line (near bus power supply
10-801 and direct current power supply 10-805-01) in order to avoid also amplifying the
interference supplies (these negatively affect the image quality).
Which cables are required?
Niko recommends the following:
- JYSTY(-F2) min. 3 x 2 x 0.8mm
- TVVF (-F2) min. 3 x 2 x 0.8mm
- TPVF min. 3 x 2 x 0,6mm (Limits the number of components to be connected. For
specifications, see technical catalogue Niko Access Control).
Note: A cable with 4 (twisted) pairs has the advantage of offering sufficient spare pairs
in case one pair is damaged.
2. INSTALLATION AND CONNECTION
This video splitter is suitable for DIN-rail mounting.
For the connection of the bus and the video signal, see fig.1 and 2.
➊ connection terminals video output 1
➋ connection terminals video output 2
➌ J1: terminal resistor
➍ J2: 5/6-wire cabling
➎ connection terminals video output
EN
➊
14 15 16 17 18 19 20 21 22 23 24 25
OUT1
14 15 16 17 18 19
a b P M V1 V2
➌
1 2 3 4 5
➍
➋
OUT2
20 21 22 23 24 25
a b P M V1 V2
a b P M V1 V2
6 7 8 9 10 11
IN
10-824-01
6 7 8 9 10 11 12
➎
13
9