Finishing The Installation - Kichler Starkk 52 Manuel D'instructions

FINISHING THE INSTALLATION

Step 1. Tuck all the connections neatly into the ceiling outlet box.
Step 2. Slide the canopy up to the mounting bracket and place one of the key hole
slots over the mounting screw on the mounting bracket. Rotate the canopy until the
screw head locks in place at the narrow section of the key hole. See figure 13.
Step 3. Align the remaining circular holes on the canopy with the remaining holes on
the Ceiling Mounting Bracket. Insert and tighten the mounting screw you removed
earlier and the mounting screw from Step 2 above. Attach the canopy cover to the
mounting screw heads by inserting the screw heads into the bottom side of the
canopy cover and rotating the cover clockwise.
NOTE: Adjust the canopy screws as necessary until the canopy and canopy cover are
snug. (Fig. 13)
Warning: Make sure the "Check Tab" at the bottom of the hanger bracket is properly
seated in the "Registration Slot" on the side of the hanger ball before attaching the
canopy to the bracket. Failure to properly seat the "Check Tab" could damage the
electrical wires when the ceiling fan blade direction is changed while the fan is running.
12 | KICHLER.COM
Outlet box
Ceiling
mounting
bracket
Screws
Canopy cover
Fig. 13
Screws
Canopy