Finishing The Installation - Kichler Chiara 52 Manuel D'utilisation

MAKE THE ELECTRICAL CONNECTIONS
Step 4. Peel o the liner paper on the receiver, secure the receiver
in place on the mounting plate cover, and keep flat in opposition of ceiling.
(Fig. 10)
NOTE: Carefully tuck the wire connections up into the outlet box.
NOTE: Fan must be installed at a maximum distance of 30 feet from the
transmitting unit for proper signal transmission between the transmitting
unit and the fan's receiving unit.

FINISHING THE INSTALLATION

NOTE: Before continuing , make sure the power is disconnected by turning
o the circuit breaker of removing the fuse at the circuit box.
Step 1. Remove the screw marked with a dot label pre-installed on mounting
plate and keep for later use. Loosen the other two (do not remove). (Fig. 11)
Step 2. Lift up the motor body onto the mounting plate, place the two slot holes
on the mounting plate cover over the 2 screws previously loosened from the
mounting plate. Rotate the mounting plate cover until it locks in place at the
narrow end of the key holes. Secure by tightening the 2 screws and the one
previously removed.(Fig. 11)
10
Receiver
Receiver
Liner Paper
Motor Body
Fig. 10
Mounting Plate
Motor Body
Fig. 11
Receiver
Ceiling Plate Cover
Screw