Installation - Blumfeldt Silver Bar 2000 Mode D'emploi

INSTALLATION

Wall mounting
1. There are 4 brackets and fasteners used with the heater. Furthermore, in
the canal of back side of the heater there are 4 square fastener washers
25×25mm. Take the square washers (Figure 1)and fasten 2 brackets to the
canal of the backside of the heater by the help of screws (Figure 2) .
2. Fasten the brackets at the appropriate distance of each other (45-55cm)
(Figure 3).
3. Two other brackets are fastened by the help of fasteners at the
appropriate distance on the wall parallel to the floor (At least 1.8 m from
the floor and at least 0.5 m from the ceiling). (Figure 4).
Fig. 1
Fig. 2
Fig. 3
EN
17