Bosch GCM18V-12GDC Consignes D'utilisation/De Sécurité page 57

1609B06757.qxp_GCM18V-12GDC 3/25/20 12:35 PM Page 57
Crown Molding Auxiliary
Fence
lying flat on the table, narrow cut-off
pieces (2" [50mm] or less in width) may
be propelled at high speed over the fence
and beyond the back of the tool (see Fig.
59). Use auxiliary fence as instructed and
shown in figures below.
MAKING AN AUxILIARY FENCE:
FIRST-TIME USE OF THE AUxILIARY
FENCE:
Saw Operations
When making a com-
pound cut on a molding
Fig. 59
Small Cut-off Piece
Fig. 60
Small Cut-off Piece
Be aware of the path of
the saw blade. Make a
dry run with the saw Off by conducting a
simulated cutting cycle, and observe the
projected path of the saw blade. Keep
hands at least six (6) inches (152mm)
away from the projected path of the saw
blade.
Stationary Fence
Auxiliary Fence
57