Bosch GCM18V-12GDC Consignes D'utilisation/De Sécurité page 54

1609B06757.qxp_GCM18V-12GDC 3/25/20 12:35 PM Page 54
CROWN MOLDING ANGLED TO
TABLE AND FENCE
Follow these instructions for cutting
crown molding angled to table and fence.
dry run with the saw Off by conducting a
simulated cutting cycle, and observe the
projected path of the saw blade. Keep
hands at least six (6) inches (152mm)
Assumptions:
Any Crown Molding Up To 6" (152mm)
Note: Always place bottom edge
against fence
Inside Corner -
Left end
Use the left end of the cut
Right end
Use the right end of the cut
Outside Corner -
Left end
Use the left end of the cut
Right end
Use the right end of the cut
54
Saw Operations
Be aware of the path of
the saw blade. Make a
Miter and Bevel Settings for Standard Crown Molding Cuts
Miter (Table)
Setting
45° Right
45° Left
45° Left
45° Right
Crown Molding
Angled
Against Fence
Optional Crown Stop
away from the projected path of the saw
blade.
Bevel (Tilt)
Setting
Inside
Corner
0° Left
Fence
0° Right
0° Right
0° Left
Fig. 57
Bottom
Edge of
Molding
45° Miter
Outside
Corner
Bottom Edge
Molding Placed
Upside Down
Crown
Stop
Table