Cadac SKOTTEL BRAAI Mode D'emploi page 8

8. General Maintenance
• This appliance does not require scheduled maintenance.
Replacing a Blocked Jet:
• Your appliance is fitted with a specific size jet (O) to regulate the correct amount of gas.
• Should the hole in the Jet (O) become blocked, this may result in a small flame or no flame
at all. Do not attempt to clean the Jet (O) with a pin or other such device as this may damage
the orifice, which could make the appliance unsafe.
• To replace the Jet (O):. Unscrew the 3 screws on the bottom housing cover and remove cover.
• Remove Valve base plate assembly by unscrewing the six self-tapping screws fixing it to the
tripod housing (J) and subsequently remove the valve (M) from the housing simply by sliding
it out.
• The jet (O) will now be accessible at the top of the valve (M).
• Unscrew the jet (O) from the valve (M) using a suitable spanner.
• Do not use pliers on the jet as this may damage the jet, making it unusable or impossible to
remove. Screw the new jet into the valve. Do not over-tighten as this may damage the jet.
• Re-fit the valve and baseplate in the reverse order of assembly. When re-fitting the valve,
ensure that the valve spindle aligns with slot in the tripod housing.
• Reconnect the gas supply as described in the Assembly Instructions
Replacing the Hose:
• The fitting of a hose is described in Section 4.
9. Cleaning
• Note: For Parts Reference (See Fig.2)
For Skottel Braai
• After cooking, leave the burner on low with soapy water in the cooking dish to soften cooking
residue. When satisfied that e xcess fat has been removed, wash the Skottel BBQ (A) in
warm water using a suitable non-abrasive detergent. Do not use sharp metal objects or
abrasive detergents on the vitreous enamel coated surface.
• After cleaning recondition the surface with a light wipe of oil.
• Remove the fat from the moat of the Burner Pan (F), wash it with warm water using a
suitable non-abrasive detergent. Do not use sharp metal objects or abrasive detergents.
For Grill2Braai & Paella Pan
• The grill plate is coated with a tough durable non-stick coating that has been used with great
success on some of the best cookware in the world. Nevertheless, taking care of it can help
you to enjoy extra years of healthy, easy, non-stick cooking.
• Use only low or medium heat settings to help retain the valuable nutrients in the food and
maintain the non-stick surface.
• Whilst the non-stick coating is very durable, it can easily be damaged by the use of metal
cooking utensils. It is therefore recommended that only plastic or wooden utensils be used
when cooking.
• Do not overheat the grill plate and always add a little cooking oil to the surface before use.
• Always allow the grill plate to cool before immersing it in water.
• The use of abrasive detergents is not recommended, as this will permanently damage the
non-stick surface.
• After cleaning recondition the surface with a light wipe of oil.
• Remove the fat from the moat of the Fat Pan.
• Note: For stubborn stains, oven cleaner may be used.
10. Storage
• Always allow the unit to cool down before packing any part into its bag.
• Always store your CADAC Braai in the supplied bags, in a dry environment, preferably off the ground. This is especially important for
the Burner pan stored in the Main bag so as to prevent the ingress of dirt or insects that may affect the gas flow.
• Should the appliance operate abnormally after storage and all checks referred to in Sections 5 & 7 have not isolated any problem, the
Venturi may be blocked. A blocked Venturi would be indicated by a weaker yellowish flame or no flame at all in extreme cases. Under
these circumstances it will be necessary to remove the burner (G) as described under Section 8 - General Maintenance, and to check
and thoroughly clean out any foreign matter which may have gathered in the venturi.
11. Returning the appliance for Repair, Service & Warranty
• Do not modify the appliance, as this could be dangerous.
• If you cannot rectify a fault by following these instructions, contact your local CADAC distributor for details on how to return the
product for attention.
• Your CADAC Appliance is guaranteed by CADAC for a period of 2 years against factory fault.
6 6
O
M
N
GB
Fig. 8a
Fig. 8b
J
Fig. 9