Cadac SKOTTEL BRAAI Mode D'emploi page 4

• Do not cover up or change the burner pan (F) air holes on the base plate, as it will influence the flow of air to the stem air holes
located inside the tripod housing (J). This, in turn, will affect the performance of the product and may lead to an unstable flame
• Ensure the appliance is used away from flammable materials. Minimum safe distances are: Above the appliance 1.2m. At the rear and
sides 600mm. (See Fig.1)
• Caution: Accessible parts may become very hot, the use of protective gloves is recommended.
• Keep young children away from the appliance.
• Use Outdoors Only
Light back
• In the event of light back (where the flame burns back and ignites inside the burner or venturi housing), immediately turn off the
gas supply by firstly closing the control valve on the gas container and then the appliance valve (M). After the flame is extinguished,
remove the regulator and check the condition of the seal; replace the seal if in doubt. Re-light the appliance as described in Section 7
below. Should the flame persistently light back, return the product to your authorised CADAC repair agent.
Leaks
• If there is a leak on your appliance (smell of gas), take it outside immediately into a well-ventilated flame-free location where the leak
may be detected and stopped. If you wish to check for leaks on your appliance, do it outside. Do not try to detect leaks using a flame;
use soapy water.
• The correct way is to smear the joints with soapy water. If a bubble or bubbles form then there is a gas leak. Immediately turn off the
gas supply firstly by closing the control valve on the gas container and then the appliance valve. Check that all the connections are
properly fitted. Re-check with soapy water.
• If a gas leak persists, return the product to your CADAC dealer for inspection / repair.
3. Components
A
Skottel Dish
C
Pot Stand
F
Burner Pan
G
Burner
H
Stem
J
Tripod Housing
K
Control Knob
L
Leg
B
Grill2Braai Grid
Q
Paella Pan
A
C
F
G
H
J
K
L
2 2
Fig. 2a
GB