Fein CG 10-115 PDE Serie Mode D'emploi page 21

OBJ_BUCH-0000000331-002.book Page 21 Thursday, June 27, 2019 3:07 PM
Dry grinding (figure 9).
Observe a lead angle of 20 – 40°. This will
ensure a good removal rate.
Apply uniform pressure with the power
tool and move it over the surface.
Avoid excessive heating of the work-
piece surface.
Cutting (figure 10).
Always work in an up-grinding motion,
so that the cutting disc will not jump out
of the cut.
Fig. 9
Fig. 10
en
21