Christie L2K1500 Guide De Référence Rapide page 6

Air Circulation
Openings in the cabinet are provided for ventilation.
To ensure reliable operation of the product and to
protect it from overheating, these openings must not
be blocked or covered.
CAUTION
Hot air is exhausted from the exhaust vent. When
using or installing the projector, the following
precautions should be taken.
– Do not put any flammable object or spray can near
the projector, hot air is exhausted from the air vents.
– Keep the exhaust vent at least 3' (1 m) away from any
objects.
– Do not touch peripheral parts of the exhaust vent,
especially screws and metallic parts. These areas will
become hot while the projector is being used.
– Do not put anything on the cabinet. Objects put on
the cabinet will not only get damaged but also may
cause fire hazard by heat.
– Do not cover vents with papers or other materials.
– Make sure that there are no objects under the
projector. An object under the projector may prevent
the projector from taking cooling air through bottom
vent.
– When detaching the adjustable feet, always keep at
least 50 mm between the bottom of the projector
and installation surface.
Cooling fans are provided to cool down the projector.
The fans' running speed is changed according to the
temperature inside the projector.
EXHAUST VENTS
Remote Control Battery Installation
1
Open the battery
compartment lid.
Pull up the lid
and remove it.
To ensure safe operation, please observe the following precautions :
● Use two (2) AAA or LR03 type alkaline batteries.
● Always replace batteries in sets.
● Do not use a new battery with a used battery.
● Avoid contact with water or liquid.
● Do not expose the remote control to moisture or heat.
● Do not drop the remote control.
● If the battery has leaked on the remote control, carefully wipe the case clean and install new batteries.
● Risk of an explosion if battery is replaced by an incorrect type.
● Dispose of used batteries according to the instructions or your local disposal rule or guidelines.
AIR INTAKE VENT
2
Install new batteries into
the compartment.
- 4 -
Moving the Projector
Retract the adjustable feet to prevent damage
to lens and cabinet. For safety, holding the
carrying handles on both sides by 2 or more
people is recommended to move the projector
because the projector is heavy. Moving it
improperly may result in damage of cabinet or
person's injury.
CAUTION IN CARRyING OR
TRANSPORTING THE PROjECTOR
– Do not drop or bump the projector, otherwise
damages or malfunctions may result.
– When carrying the projector, use a suitable carrying
case.
– Do not transport the projector by courier or any
other transport service in an unsuitable transport
case. This may cause damage to the projector. For
information about transporting the projector by
courier or any other transport service, consult your
dealer.
– Do not put the projector in a case before it is cooled
enough.
– Do not transport the projector with a replacement
lens installed.
3
Two AAA size batteries
For correct polarity (+ and –),
be sure battery terminals are
in contact with pins in the
compartment.
Replace the compartment
lid.
020-000410-01 Rev.1 (05-2011)