Electrode Winter Break; Coming Season Start-Up Procedures; Returned Goods Procedure; Guarantee Certificate - aqua A-TECHNOPOOL 3 SYSTEM pH-RX Manuel De Service Et D'entretien

9 Electrode winter break

Remove the electrodes during winter break. Fill in the protection cap with 1/3
of water and put it on the electrodes.

10 Coming season start-up procedures

- It's recommended to install a new electrode when season begin, in order to prevent failure
during season.
- After the electrode replacement or start up of the apparatus, repeat the calibration procedure.

11 Returned goods procedure

The product must be sent back to the Manufacturer packed into it's own packaging, with all
original protections, within the guarantee period.
The dosing pump must be properly washed with water in order to remove the chemical
residuals from internal parts.
The electrode must be packed into it's own original box and provided by the protection cap duly
filled in water.
If the above mentioned conditions will not be respected , the Manufacturer disclaim all
responsibility for eventual damages occurred during transport.

12 Guarantee certificate

the Manufacturer guarantee the products for 24 months from the shipment date to the first
Customer.
During this period the Manufacturer will supply for free those components that, upon verification
by the Manufacturer or an Authorized distributor, might reveal defective; from this guarantee are
excluded all components subject to normal wear and tear, such as valves, gaskets, fittings, ring
nuts, tubes, filters, valve injection, probes, electrodes and components in glass.
the Manufacturer reserve the right to repair or to replace the defective product.
the Manufacturer will not be responsible for any other claim by the customer for any direct or
indirect damages caused by the use or by the impossibility to use, totally or partially, the
product.
The reparation or replacement do not extend or renew the warranty period.
All expenses related to assembling and disassembling of the apparatus, transport, and used
materials (filters, valves, etc.), remain at customer' cost
The reparation or replacement warranty right decade in following cases:
The pump have not been used according to the instructions specified by
the Manufacturer.
The pump have been repaired, disassembled or modified by entity NON
authorized by the Manufacturer.
Non original spare parts have been used.
The injection line have been damaged by using incompatible products.
The electrical circuit board have been damaged by any external factor,
i.e.: high-tension.
24 months after the delivery date the Manufacturer will be free from all above mentioned
obligations.
A-TECHNOPOOL 3 SYSTEM pH-RX 06/04/2016 Rev.1.5 22/100