Advanced Programming; Configuration Of The Settings; Restore The Default Parameters - aqua A-TECHNOPOOL 3 SYSTEM pH-RX Manuel De Service Et D'entretien

7

ADVANCED PROGRAMMING

7.1

Configuration of the settings

To confirm and exit, press key Enter for 3 seconds.
7.2

Restore the default parameters


By activating this function, all programmed data will get lost!
A-TECHNOPOOL 3 SYSTEM pH-RX
Stabiliz. Time
When the system is powered or after an alarm occurred, it
waits a stabilisation time before it starts dosing (probes need
some minutes to stabilise the readings).
Stab. after alarm
Enables or disables the stabilisation time, after every alarm of
the system.
Time and Date
Sets hour and date of the system
Press keys ▼▲ to set the value and Enter to move the slider.
Password setting
Set the password of the system.
Press keys ▼▲ to set the value and Enter to move the slider.
User name
Set the name of the client.
Press keys ▼▲ to select a character and Enter to move the
slider.
Contact assist.
Set the name and telephone number of the After-Sales
Assistance.
Press keys ▼▲ to select a character and Enter to move the
slider.
pH Cycle period
It is the time that must pass between the two doses for the pH
pump.
Press keys ▼▲ to set the desired value and Enter to confirm.
Values that can be set for the timing are 5÷120 minutes.
Contrast
This is the contrast percentage of the LCD.
Use the ▼▲ keys to set the desired value and then confirm
with the Enter key. The time values that can be set are
1÷100.
The restoration of the factory parameters is enabled (refer to
appendix 1). The system asks if you are sure to proceed.
Press keys ▼▲ to select the two options and Enter to confirm.
06/04/2016 Rev.1.5 19/100