Gaspardo MTE-R Emploi Et Entretien page 59

4.6 SEED SELECTION
4.6.1 SEED DISTRIBUTOR
REPLACEMENT OF SEED DISC AND ADJUSTMENTS
All operations described in this paragraph must be carried
out by expert personnel, equipped with protective gloves, in
a clean and dust-free environment.
- The seeder must be clean and dry and stably positioned.
- If the power take-off is hooked to the tractor it must
the hand brake pulled.
- Only clean parts in good condition must be installed.
- The plate must be assembled with the pegs (2, Fig. 14) poin-
ting towards the inside of the distributor.
- If some of the pegs are bent or missing from the plate, this
means that foreign bodies have entered the distributor, in
which case the plate must be replaced.
- If there are circular scratches, they must not exceed 1/3 of
the plate thickness.
- Hand-tighten only the winged nut that closes the cover (Fig.
15).
N.B. When replacing worn plates, the cover gasket should
also be replaced.
These are the operations to be carried out:
COVER SEAL (plastic)
Also check that no grooves have been made by the disk along
Replacing the cover seal
cod. G19504610
Table 3
CAUTION
USE AND MAINTENANCE
1
b e
B2
B1
A
C
3,5÷4 Nm
ENGLISH
2
B2
B1
A
D
E
G
F