Bomba NIAGARA:Bomba NIAGARA.qxd 27/01/2010 18:01 Página 12
3.6
Those elements of the equipment wich,
when functioning, are in movement or
which could reach dangerous temperatures,
will be protected with cages or casing
which will prevent accidental contact
with the same.
3.7
Electricity conductors, or parts which
could carry current, will be suitably
insulated. Other metal parts of the
equipment will be correctly earthed.
3.8
Spare parts that may be necessary will
be originals from the manufacturer or
those recommended by the manufacturer.
The use of others, or originals rectified
by others, are not permitted and release
the manufactured of distributor from all
liability.
4. PACKING, TRANSPORT AND
STORAGE
4.1
ATTENTION
The manufactured supplies the equipment
protected in suitable packaging, so that
it is not damaged during transport or
storage thus preventing its correct
installation and/or functioning.
4.2
ATTENTION
The user, upon receipt of the equipment,
will immediately check the following
points:
- Condition of the outside packaging, if
this shows sings of serious deterioration,
he
shall formally advise the person
delivering the equipment.
- He shall also check the condition of
the contents; should this show defects
which
would
presumably
correct functioning, he shall also formally
notify the supplier within a period not
exceeding 8 days from the date of delivey.
4.3
ATTENTION
Storage conditions must ensure the
optimum
preservation
equipment.
Due
relevance, we must stress that very
damp atmospheres or others where
brusque changes in temperatures
(which cause condensation) must be
avoided
5. INSTALLATION AND ASSEMBLY
5.1. LOCATION.
ATTENTION
The place where the electropump is to
be located must be dry. In all events,
there must be a drain in the floor as a
prevention against flooding. If the pump
is to be located in a damp place, a
ventilation system must be provided in
order to prevent the formation of
condensation.
12
prevent
of
the
to
its
particular