Bosch GLM 100 C Consignes D'utilisation/De Sécurité page 28

b) Double indirect height measurement (see figure D)
Press the function-mode button 8 until the indication for double indirect
height measurement
Measure distances "1" and "2" in this sequence as for a length
measurement.
remains exactly at the same location for all individual measurements within
a measuring sequence.
c) Indirect length measurement (see figure E)
Press the function-mode button 8 until the indication for indirect length
measurement
Pay attention that the measuring tool is positioned at the same height
as the sought measuring point. Now, tilt the measuring tool around
the measurement reference and measure distance "1" as for a length
measurement.
The wall surface measurement is used to determine the sum of several
individual surfaces with a common height.
In the example shown, the total surface of several walls that have the same
room height A, but different lengths B, are to be determined.
Upon completion of the measurement, the result for the
sought distance "x" is displayed in the result line c. The
measuring values for the distance "1" and the angle "a"
are displayed in the measured value lines a.
1
appears on the display.
1
2
1
Upon completion of the measurement, the result for the
sought distance "x" is displayed in the result line c. The
measuring values for the distances "1", "2" and the angle
"a" are displayed in the measured- value lines a.
Pay attention that the measurement reference of the
measurement (e.g. the rear edge of the measuring tool)
appears on the display.
1
1
2
Upon completion of the measurement, the result for the
sought distance "x" is displayed in the result line c. The
measuring values for the distance "1" and the angle "a"
1
are displayed in the measured value lines a.
Wall Surface Measurement (see figure F)
-28-