Publicité
Les langues disponibles
Les langues disponibles
en
INSTALLATION FENCE TAPE / TWINE
Now build your fence. Fence the selected terrain.
If you have a set with plastic posts, then proceed as follows:
You insert the plastic stakes into the ground around the site approximately 3 to 5m apart, depending
on the size of the site and how it fits best. Then always tension the tape/twine at the same height of the
insulators on the post, so that you achieve a complete line. At the end of this line, tension the tape/twine
one level lower or higher and tension again to the end of the first post. In this way you can tension 4 to
5 lines on the posts.
When you have fully stretched the tape/twine, now connect the red cable to the electric fence device (red
button) and to the fence line.
Important: In general, the tape/twine must never lie on the ground or touch undergrowth or anything
else. The tape/twine may only lie in the insulators. If the tape/twine is on the ground, there is a dissipa-
tion at the fence and the fence becomes ineffective because the energy goes into the ground and not
onto the fur of the animal.
Notice:
We recommend using wooden posts at the beginning, end and corners of the fence for more stability.
That is why insulators are included in the set with posts. Installation is not a must, but more optimal for
tensioning the fence material.
Electric fence tape/twine is easy to hang up.
12
Attention:
The electric fence tape/twine
does not have to be fed back to
the electric fence device.
Publicité
