Cleaning And Lubrification; Service And Maintenance Schedule - BEEQ C800 Trekking Manuel De L'utilisateur

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

WARNING
If the bike chain is worn, it can break and cause a crash. If your bike chain is worn, have
it replaced by your specialist cycle shop before using the bike again.
7.6.

Cleaning and Lubrification

The bike must be protected against environmental influences such as dirt, perspiration and
salt when using the bike during winter or in the sea air. The bike should be cleaned with a
wrung-out cloth. A small amount of mild detergent may be added to the cleaning water. Finally,
the bike should be protected with a small amount of maintenance product.
WARNING
It is always important to ensure that all friction surfaces of the brakes do not come into
contact with any lubricants or other maintenance products.
If the disc pads are polluted, it can strongly reduce the braking performance.
If brake pads are polluted, they must be replaced immediately.
The electric drive system is only protected against ordinary splashes of water. It must
not be cleaned with high pressure water devices, jets of water or compressed air.
This could result in a short circuit, loss of function, fire and explosion
7.7.

Service and Maintenance Schedule

It is advisable to have your BEEQ serviced regularly after the bedding-in phase, which is
normal to occur, because of the relaxing of the cables tension, etc. The schedule given in the
table below is a rough guide for cyclists who ride their pedelec between 1,000 and 2,000 km or
50 to 100 hours of use a year.
If you consistently ride more or if you ride a great deal on poor road surfaces, the service
intervals will shorten accordingly.
Component
Lightning
Tires
Brake cables/pads/lines
Brakes (disc brakes)
Suspension fork/rear shock
Fork (rigid)
Bottom bracket
Chain
Derailleur gears
Telescopic seat post
22
Action
Check function
Check pressure
Check tread and side walls
Inspect visually
Check lever travel, brake pads,
seals, test brakes in stationary
Replace liquid (Use mineral brake
oil)
Check recommendation from
manufacturer
Check for cracks and replace, if
needed
Check for play
Dismount and re-grease
Check and lube, if needed
Check wear and replace if needed
Check recommendation from
manufacturer
Before
Monthly
Annually
every
ride
X
X
X
X
X
(b)
X
(b)
X
(b)
(b)
BEEQ User Manual | V6 | 2021
Other
At least every 2
years
(b) after 900kms or
40 hours of use

Hide quick links:

Publicité

Table des Matières
loading

Table des Matières