Adjusting The Gear Cables; Chain Tension - BEEQ C800 Trekking Manuel De L'utilisateur

9mm Quick-Release
1. Position the wheel on the dropouts, the axle should be on the wheel.
2. Rotate the axle clockwise, find the best closing force.
3. Close the lever
4. The force required to close should leave an imprint on your hand
To remove the wheel please do the reverse operation.
For detailed operations for your
BEEQ model, please refer to the
online specification
(https://www.beeq-
bicycles.com/the-range).
The recommended tire pressure is 2 bar, you can use a minimum of 1,5bar and the maximum
pressure engraved on the bike tire.
5.4.

Adjusting the gear cables

The gears of our bikes are adjusted during the assembly, so, you should not need to adjust it.
In the case the gears will not engage cleanly the settings in the gear lever housing will need
correcting. Unscrew the gear cable housing on the gear lever housing by hand in small steps
and check the functionality every time after a correction has been made.
In order to turn the gear cable housing, it must be pulled out a little from its position. Ensure
that it is now sitting properly before testing the functionality.
If the gear cables cannot be adjusted in this way the assembly of the gear cables should be
checked by a trained technician.
For detailed operations for your BEEQ model, please refer to the online specification
(https://www.beeq-bicycles.com/the-range).
5.5.

Chain Tension

The chain tension must be adjusted so that vertical play of one or two centimeters is present
in the unsupported chain span between the chainring and sprocket wheel.
If play is verified, to remove the slack, proceed as follows:
Loosen the rear wheel nuts.

16
Quick release tightning
BEEQ User Manual | V6 | 2021