Tightening Torque Values - BEEQ C800 Trekking Manuel De L'utilisateur

WARNING
If you install clipless pedals, please refer to the manufacturer user manual for
installation procedures.
Be sure you are familiar to the clipping and unclipping process, there's a risk of fall or
injuries.
5.8.

Tightening torque values

To guarantee the reliability of your bike, it is imperative that you tighten the screws of all
components carefully and regularly check them. Use a torque wrench in order to check these
values. Always tighten in a progressive manner in order not to apply a torque higher than the
recommended values.
Never go over the recommended maximum torque value in any case.
On some parts, the recommended torque values are indicated on the part itself. Always respect
these recommended levels. If you cannot find the correct torque rate for your component,
check the specific notice that was provided with your bike, or ask your retailer for advice.
Component
Transmission
Rear derailleur
Gear lever
Cassette
Crank
Pedal
Cockpit
Saddle on seat post
Seat post
Stem
Grips
Accessories
Classic luggage rack
Mud guard
Pedals
Kick-stand
Brakes
Brake caliper
Brake lever on handlebar
Disc brake
Drive System
Crank
Spider
Chainring
18
Screws and bolts
Fixation screw
Cable screw
Tension screw
Fixation screw
Tightening screw
Fixation screw on motor axle
Pedal axle
Seat post with 1 fitting block
Seat post with 2 fitting blocks
Seat post clamp
Screw on the handlebar
Screw on the pivot
Angle screw
Screw on the stem cover
Fixation screw
Fixation screw on the frame
Fixation screw on the fork
Fixation screw on the support
Fixation screw on luggage rack/frame
Fixation on crank
Fixation screw
Fixation screw on the frame/fork
Fixation screw on the brake lever
Fixation screw on the hub
Centerlock lock ring
Fixation screw on the motor
Fixation screw on the motor
Fixation screw on spider
Torque value
8-10 Nm
6-7 Nm
3-4 Nm
5 Nm
35-45 Nm
45-50 Nm
25 -30 Nm
18-20 Nm
8 Nm
5 Nm
5-6 Nm
6-8 Nm
14-15 Nm
4-5 Nm
3 Nm
8-10 Nm
5 Nm
3 Nm
5 Nm
18-22 Nm
10-14 Nm
6-8 Nm
4-5 Nm
5-7 Nm
35-45 Nm
57-64 Nm
25-30 Nm
10 Nm
BEEQ User Manual | V6 | 2021