WARNING
The non-respect of the usage criteria described here can cause risk to the
user and a restriction of the warranty conditions.
CATEGORY
This is a set of conditions for the operation of a
bicycle on a regular paved surface where the tires
are intended to maintain ground contact
This is a set of conditions for the operation of a
bicycle that includes Condition 1 as well as unpaved
and gravel roads and trails with moderate grades. In
this set of conditions, contact with irregular terrain
and loss of tire contact with the ground may occur.
Drops are intended to be limited to 15cm (6") or less.
This is a set of conditions for operation of a bicycle
that includes Condition 1 and Condition 2 as well as
rough trails, rough unpaved roads, and rough terrain
and unimproved trails that require technical skills.
Jumps and drops are intended to be less than 61cm
(24").
This is a set of conditions for operation of a bicycle
that includes Conditions 1, 2, and 3, or downhill
grades on rough trails at speeds less than 40 km/h
(25 mph), or both. Jumps are intended to be less than
122cm (48").
Changing settings and carrying out repairs to the bike shall only be deemed to be in accordance
with the intended use if they are carried out as described in this instruction manual.
Adhering to the recommended operating, maintenance and monitoring measures, and reading,
understanding and observing this instruction manual are all deemed to be in accordance with
the intended use.
3.3. Emergency stop, emergency shut-off
The bike does not have a separate emergency stop or emergency shut-off.
The power will shut off as soon as the force upon the pedals stops. The bike will be
mechanically braked or stopped with the brakes.
If the pushing aid is activated the drive is interrupted as soon as the corresponding button is
no longer pressed.
The drive system will not turn itself off during braking and thus remains available at all times.
WARNING
When support mode is turned on the drive system reacts to the smallest
impulse introduced through the pedals.
Apply the brakes when getting to the bike to prevent an unintended start and
lower the risk of an accident.
The bike should only be turned on if the rider is able to brake, i.e. can reach at
least one brake
Do not perform work on the bike, without turning off the system.
10
TYPE OF USE
MODELS
Urban Models
Trekking Models
Wild Models
Full Suspension
Non applicable
BEEQ User Manual | V6 | 2021