Triton EPA 001 Instructions D'utilisation Et Consignes De Sécurité page 9

Fig. 26
Loosen the plastic wing nut on the Planer Guard Assembly
(32) and insert it fully into the front chassis tube. Retract
the guard and tighten the wing-nut to secure it in place
(Fig. 27).
Fig. 27
Fit the Tube Closer (33) into the rear chassis tube, as
shown.
Attach the Switch-Box (34) to the front brace by screwing
the Self-Tapping Screws (35) into the lower holes in the
rear of the switchbox (Fig. 28).
Depress the planer's trigger and fit the Trigger Strap (36)
(Fig. 29).
Do not leave the trigger permanently locked on. When you
have finished work for the day release the trigger strap
and allow the spring in the trigger to relax.
Make sure the switch is off (Fig. 31) and plug the planer
into its switchbox, then bring power to the switchbox via
a 10 Amp extension lead. Using a separate lead to that of
your Workcentre enables independent operation of your
saw and planer.
Press the switch with your finger to switch the power 'ON'
(Fig. 30). Tap the stop plate with your hand to switch it
'OFF' (Fig. 31).
Fig. 30
Push the Dust Hose (37) through the hole in the top of the
chassis and position it over your planer's dust outlet
(Fig. 32).
Fig. 32
Bend the hose over and secure it using the Plastic Chain
Fig. 28
(38) twist locked through the slots in the chassis edge.
Fit the Dust Bag (39) over the end of the hose and tighten
the draw string (Fig. 33).
Fig. 33
Fig. 29
As the bag fills, during use, be sure that it is seated on
the ground. Relocate the bag further down the hose if
necessary.
Fig. 31
Assembly
9
GB