Handling - Conrad DECT Mode D'emploi

10. Handling

• The product is only to be used in dry indoor locations.
The mains adapter must not get damp or wet. There is danger to life from electric
shock!
• Never use the product immediately after it was taken from a cold into a warm
environment. The resulting condensation may destroy the device. The mains
adapter also involves the risk of a mortal electric shock!
Allow the device to reach room temperature before connecting and using it. This
process may take several hours.
• Servicing or repair may only be carried out by a specialist/specialist workshop.
• Check the product for damage before each use!
If there is any damage, the product must NOT be connected to mains voltage or
switched on.
It must be assumed that safe operation is no longer possible if:
- the device shows visible signs of damage,
- the product does not work properly or not at all anymore (e.g. smell of fire)
- the product was stored under unfavourable conditions.
• When setting up the product, make sure that the cable is neither bent nor
squeezed or that you can trip over it.
• If the product is not to be used for a longer period, (e.g. for storage), pull the mains
adapter from the mains socket.
• Avoid the following adverse ambient conditions at the place of installation or
during transport:
- moisture or high humidity
- extreme cold or heat
- dust or flammable gases, fumes or solvents
- strong vibrations
26