Reset Dect Repeater - Conrad DECT Mode D'emploi

c) Reset DECT Repeater
In order to register the DECT repeater (e.g. at another DECT basis station or after unsuccessful
registration), reset the DECT repeater first.
Since no reset button is present, the DECT repeater must be connected to and disconnected
from the power supply in a certain order.
Proceed as follows:
• Disconnect the DECT repeater from the power supply (pull the mains plug from the mains
socket).
• For this, connect the DECT repeater to the power supply for 1-5 seconds. Then disconnect
it from the power supply (for a few seconds).
• For this, connect the DECT repeater to the power supply for 25-35 seconds. Then disconnect
it from the power supply.
• The DECT repeater is now reset and can be registered again.
24