Télécharger Imprimer la page

Scheppach HC24V Traduction Du Manuel D'origine page 73

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 11
12. Troubleshooting
Fault
The compressor does
not start.
The compressor starts
but there is no pres-
sure.
The compressor starts,
pressure is shown on
the pressure gauge, but
the tools do not start.
Heruntergeladen von
manualslib.de
 www.scheppach.com  service@scheppach.com  +(49)-08223-4002-99  +(49)-08223-4002-58
Possible cause
• No supply voltage.
• Insufficient supply voltage.
• Outside temperature is too low.
• Motor is overheated.
• The non-return valve leaks.
• The seals are damaged.
• The drain plug for condensation water (1)
leaks.
• The hose connections have a leak.
• A quick-lock coupling has a leak.
• Insufficient pressure set on the pressure
regulator (7).
Handbücher-Suchmachiene
Remedy
• Check the supply voltage, the power plug and the
socket-outlet.
• Make sure that the extension cable is not too
long. Use an extension cable with large enough
wires.
• Never operate with an outside temperature of
below +5° C.
• Allow the motor to cool down. If necessary, rem-
edy the cause of the overheating.
• Have a service center replace the non-return
valve.
• Check the seals and have any damaged seals
replaced by a service center.
• Tighten the screw by hand. Check the seal on
the screw and replace if necessary.
• Check the compressed air hose and tools and
replace if necessary.
• Check the quick-lock coupling and replace if
necessary.
• Increase the set pressure with the pressure
regulator.
GB
73

Publicité

loading