Scheppach 5910602900 Traduction Du Manuel D'origine page 17

Troubleshooting
Problem
The device does not start.
The tool works intermit-
tently.
The safety cutter bar gets
hot.
Poor cutting quality
 www.scheppach.com  service@scheppach.com  +(49)-08223-4002-99  +(49)-08223-4002-58
Possible cause
The battery is discharged.
The battery is not inserted.
The safety switch has not been activated
correctly.
The on/off switch is faulty.
Loose internal connection
The on/off switch is faulty.
The safety cutter bar is blunt.
The safety cutter bar has notches.
Too much friction owing to lack of lubrica-
tion.
Too much friction owing to lack of lubrica-
tion.
Dirty safety cutter bar
The safety cutter bar is blunt.
Bad cutting technique
Solution
Charge the battery.
Insert the battery.
Switch on.
Repair by an authorised service centre.
Repair by an authorised service centre.
Have the safety cutter bar checked or re-
placed (service centre).
Oil the safety cutter bar (2).
Oil the safety cutter bar (2).
Clean the safety cutter bar.
Have the safety cutter bar sharpened or
replaced (service centre).
See "Working with the tool".
17 І 56