Yamaha A-S2100 Mode D'emploi page 18

Connections
■ Connecting the speakers
1
Remove approximately 10 mm of insulation
from the end of each speaker cable and twist
the exposed wires of the cable together to
prevent short circuits.
10 mm
2
Unscrew the knob and then insert the bare
wire into the hole.
3
Tighten the knob.
Caution
When loosening the knob of the speaker terminal, do not rotate it
excessively. The knob may come off and pose the danger of being
swallowed by a child.
Notes
• Touching the speaker terminal with a metallic rack may cause
short circuit and damage this unit. When installing the unit in a
rack, maintain a sufficient clearance to prevent the speaker
terminals from touching the rack.
• To reduce the risk of electric shock, do not touch the speaker
terminal when the unit is turned on.
18
En
Hole for speaker cable:
6.0 mm dia.
■ Connecting the banana plug
(Except for Europe models)
First, tighten the knob and then insert the banana
plug into the end of the corresponding terminal.
Banana plug
■ Connecting the Y-shaped lug
1
Unscrew the knob and then sandwich the Y-
shaped lug between the ring part and base.
Slide
Terminal screw for Y-shaped
lug: 5.8 mm dia.
2
Tighten the knob.
Hole for banana plug:
3.95 mm dia.
Y-shaped lug