Textron Company Ransomes LQ Serie Manuel De L'opérateur Et De Sécurité page 24

8 ADJUSTMENTS
GB
HEIGHT OF CUT ADJUSTMENT (WING DECKS)
The cutting height is determined by the position of
the blades in relation to the caster wheels. Changes
to this height are made at (4) points and can be
made in any order. Make selections for each
adjustment below from the accompanying height of
cut charts .
1. Raise the deck.
2. Remove the quick pin Q from the top of the
caster wheel pivot spindle.
3. Remove the caster wheel from caster
support M.
4. Select either Position 1 or Position 2 for
wheel mounting bracket. To change,
remove (4) mounting bolts R.
5. Place the selected size and number of
spacers below the caster support. Both A-
size (6.5 mm) and B-size (12.5 mm)
spacers are provided. Place the remaining
spacers above the caster support.
6. Replace the quick pin.
7. Place pin P into proper hole of front caster
bracket for the selected height of cut.
8. Place chain pin T into the proper hole of
chain adjustment bracket for the selected
height of cut.
GB-22
FRONTLINE 960 Series: LQ
SAFETY AND OPERATORS MANUAL