Hydraulic Lift Levers; Cutting Unit Switches - Textron Company Ransomes LQ Serie Manuel De L'opérateur Et De Sécurité

6 CONTROLS
GB
6.9

HYDRAULIC LIFT LEVERS

The cutting units can be raised and lowered by three
control levers (A,B,C) situated on the right hand side
of the operators seat and can be operated as
follows:
Centre lever controls Centre Cutting Deck. (B)
Right hand lever controls R.H. Cutting Deck. (C)
Left hand lever controls L.H. Cutting Deck. (A)
NOTE: If any unit is raised out of work then lowered into
work again the cylinder will not rotate until the mow foot
switch is depressed.
To lift: Move the lever(s) backwards and hold in position
until the units are at the required height.
To lower: Move the lever(s) fully forwards and release,
the unit(s) will lower to ground level. DO NOT hold lever
in forward position.
NOTE: The units will only lift and lower when the engine
is running.
IMPORTANT: If, when cutting, a lift control lever is
accidentally pulled back, the cutting units will not float
over ground undulations until the lever is pushed fully
forward and allowed to return to neutral again.

6.10 CUTTING UNIT SWITCHES

To commence cutting ensure speed limiter is in
mow position and the units have been lowered.
Push bottom of the rocker switch (G) and depress
foot switch (A) Push top of rocker switch to stop
cutter unit rotation. (Cutting unit stop rotating
automatically when raised.)
GB-12
FRONTLINE 960 Series: LQ
SAFETY AND OPERATORS MANUAL