Kenwood DDX9907XR Guide De Démarrage Rapide page 30

Connection/Installation
Ñ
3-way speaker system setup
● DDX9907XR / DMX957XR / DMX907S
Subwoofer Preout
Mid Range Preout
Tweeter Preout
When connecting to an external amplifier,
connect its ground wire to the car's chassis to
avoid damaging the unit.
Preout
RCA Cable
(Sold separately)
Power amplifier
(optional
accessory)
Input
White
White/Black
Gray
Gray/Black
Green
Green/Black
Purple
Purple/Black
Speaker impedance: 4-8 Ω
NOTE
• For speaker system setup, see 3-way speaker
system setup (P.87) in the Instruction Manual.
• For speaker setup and crossover setup, see
Speaker / X'over setup (P.88) in the
Instruction Manual.
• For how to connect speaker wires to terminals
other than speaker terminals and Preout
terminals, see Connecting the system and
external components (P.30) and Connecting
wires to terminals (P.29).
30
Speaker
+
To mid range left
speaker
+
To mid range right
speaker
+
To tweeter left speaker
+ To tweeter right
speaker
Ñ
Connecting the system and
external components
9 8
1
2
3
1 AV Audio output (ø3.5 mini jack)
FM/AM antenna input
2
When connecting to an external amplifier,
3
connect its ground wire to the car's chassis to
avoid damaging the unit.
Rear Audio Preout
(Left; White, Right; Red)
Front Audio Preout
(Left; White, Right; Red)
Subwoofer Preout
(Left; White, Right; Red)
4 SiriusXM Connect Vehicle Tuner connector
For more information on how to install the
SiriusXM Connect Vehicle tuner, consult the
installation guide included with the tuner.
iDatalink connector
5
This jack accepts either AV-IN or camera input.
6
For more information, see To set up the
camera assignment settings (P.34).
[DDX9907XR / DMX957XR / DMX907S :]
Accessory -: Mini plug to RCA cable*
or CA-C3AV (optional accessory)
[DDX9707S / DMX9707S :]
CA-C3AV (optional accessory)
13
12
11
10
7 6 5
4
1