Prior To The First Measurement; Setting Date, Time, And Unit Of Measure; Selecting The User - Soehnle SYSTO MONITOR 100 Mode D'emploi

Setting date/time/unit of measure
Date and time must be set prior to using the blood
pressure monitor so that every measurement value
that is stored can be time stamped.
1. If the device is switched off, push the key (
to display the time. Then push and hold the key
( ) to set the year.
2. Push the key ( ) to change the [YEAR]. Each
time you push the key, the year increases by one.
3. Once the year has been set, push key (
save the information and continue.
4. Repeat steps 2 and 3 to set [MONTH], [DAY],
[HOUR], [MINUTE] and [UNIT OF MEASURE]
You can switch between the unit of measure
"kPA" (kilo pascal) or "mmHg" (millimetre
mercury column), where mmHg is the most
common unit for measuring blood pressure.

PRIOR TO THE FIRST MEASUREMENT

5. After setting the unit of measure, the LCD display
shows "done" and then displays all settings
entered by you before switching off.

Selecting the user

)
A total of two users can be programmed. 60
datasets can be stored for each user.
1. If the device is switched off, push and hold the
key ( ) to select the user. The user symbol
( ) flashes.
) to
2. Push key (
2 or "Guest" (guest mode).
No measurements are stored in guest mode.
3. Confirm the selection of the respective user by
pushing (
are shown before the display switches off.
) again to select between user 1,
). The respective user and "done"
EN
35