Ezlink; Emc; Agréments, Certification Et Sécurité - ABB AWT420 Instructions De Mise En Service

AW T4 2 0 | T R A N S M E T T E U R 4 F I L S U N I V E R S E L D O U B L E E N T R É E | C I/A W T4 2 0 - F R R É V. C

EZLink

Consommation électrique (maximale)
150 mA @ 24 V CC (3,75 W max.)
Câble de longueur fixe
1 ou 10 m (3,28 ou 32,8 pi.)
Degré de protection IP du connecteur du capteur numérique
IP67 (connecté)
Rallonge (options)
1, 5, 10, 15, 25, 50 m (3.2, 16.4, 32, 49.2, 82, 164 pi.)
Longueur maximale (avec rallonge en option)
Jusqu'à 210 m (826 pi.)

EMC

Émissions et immunité
Conforme à la norme CEI 61326 dans le cadre d'une
utilisation dans un environnement industriel
Agréments, certification et sécurité
Agrément de sécurité
cULus
marquage CE
Conforme aux directives EMC et LV
(y compris la nouvelle version CEI 61010)
Sécurité générale
• IEC 61010-1
• Pollution catégorie 2
• Isolation Classe 1
Bluetooth
Le module Bluetooth basse consommation du transmetteur
AWT420 a reçu l'approbation réglementaire pour les pays
suivants :
• Europe/CE
Europe
0197
• Japan/MIC: 005-101150
Japan
Contains transmitter module with certificate number:
005-101150
• Korea/KCC: MSIP-CRM-mcp-BM71BLES1FC2
Korea
MSIP-CRM-mcp-BM71BLES1FC2
• China/SRRC: CMIIT ID: 2016DJ5890
China
CMIIT ID: 2016DJ5890
• United States/FCC ID: A8TBM71S2
U.S.
Contains FCC ID: A8TBM71S2
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) this device may not cause harmful interference,
and (2) this device must accept any interference
recieved, including interference that may cause
undesired operation.
This equipment has been tested and found to comply with
the limits for a Class B digital device, pursuant to part 15
of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference
in a residential installation. This equipment generates,
uses and can radiate radio frequency energy, and if not
installed and used in accordance with the instructions,
may cause harmful interference to radio communications.
However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference
by one or more of the following measures:
– Reorient or relocate the receiving antenna.
– Increase the separation between the equipment
and receiver.
– Connect the equipment into an outlet on a circuit
different from that to which the receiver is connected.
– Consult the dealer or an experienced radio/TV
technician for help.
35