Publicité
Les langues disponibles
Les langues disponibles
Electric cables must be away from hot surfaces
• SCREWS AND CONNECTING CABLES: Supervise and tighten the screws on a
regular basis, because due to the vibration the screws and nuts tend to loosen.
LUBRICATION: It's a correct lubrication of the treadmill with silicon oil or
teflon is really important. This lubrication must be performed regularly
depending on its use even before the first use.There is a hole for adding
oil on motor cover. After starting machine, please change to highest
speed, then add the oil into the hole, the oil will be spread from the
middle between the running belt and board.
•
< 3 hours/week
4 – 7 hours/week
> 8 hours/week
• ALIGN AND TIGHTEN THE BELT OF THE TREADMILL
2 months
1 month
15 days
• ALIGN THE BELT: Due to its use, the belt can move off
center. If the belt has moved to the left, start treadmill
and increase the speed to 3MPH .Use the 6mm Wrench to
turn the fixed left bolt clockwise or turn the fixed right
bolt counterclockwise. Don't tighten the belt too much in
order to be able to walk. Repeat this procedure until the
belt is properly aligned.
If deviate to the left, then
adjust the screw on the left side
如果跑带左偏,则顺时针调节左
clockwise or the screw on the right
side anticlockwise.
边螺丝或逆时针调节右边螺丝
• TIGHTEN THE BELT: (if the belt slips on the treadmill
when walking). Start treadmill and increase the speed to
3MPH.Using the 6mm Wrench , turn both bolts 1/4
clockwise. If the belt is properly tight to walk, you must
be able to pull up each side of the belt 5 or 7 cm off the
platform. Be careful and maintain the belt aligned.
Repeat this procedure until the belt is properly
tightened.
If deviate to the right, then
adjust the screw on the right side
如果跑带右偏,则顺时针调节右
clockwise or the screw on the left
side anticlockwise.
边螺丝或逆时针调节左边螺丝
Publicité
