Funktel FC1 Guide Utilisateur page 81

Messaging on Mobility Server I 33 / CS I55
FC1 Ex (HS) – Commissioning
Charging the FC1 handset
Place the FC1 Ex handset into the charger. A confirmation tone is heard.
The handset remains switched on or off, depending on its status before it
was placed in the charger.
The battery symbol in the symbol line moves until the battery is fully
charged. The batteries get a little warm during the charging process, which
GB
is normal. As soon as the battery is full, trickle charging starts. This is
indicated by a blinking frame of the battery full symbol.
Charging an additional battery
An open bay is provided on the back of the table-top charger FC1 S Ex for
charging a spare battery. Place a battery into the bay with the contacts
facing downward and the securing screw bore facing outside and gently
press it down against the contact springs. As soon as the contact is
established and charging starts, the front bottom LED of the table-top
charger changes its colour from green to red.
Information on the use of the battery
Place the FC1 Ex handset in the charger for at least 14 hours every time
the battery was replaced in order to fully charge the battery. During the
first week of operation, place the handset in the charger after each use.
When new, batteries usually achieve their full capacity only after a few
days of normal use.
You may leave your handset in the charger after use, overnight and during
the weekend. The battery cannot be overcharged.
Do not leave the battery in full solar radiation. Observing these rules will
give you a long time of battery service life.
81