Blaupunkt GTA 2 Spezial Notice D'emploi Et De Montage page 8

GTA 2 SPEZIAL
amplifier. Use cable grommets when pass-
ing cables through holes with sharp edges.
Use loudspeakers with an impedance of
Ω
2 to 4 (see table or installation drawing).
Observe the max. power handling specifi-
cations (music output). Do not connect the
loudspeakers to ground; only use the termi-
nals provided. The cross-section of the pos-
itive and negative cable must be at least
2
6 mm .
GTA 2 Spezial amplifier
The amplifier is suitable for connection to car
radios with Cinch connector. Use the Blau-
punkt ISO Cinch adapter to connect the
amplifier to car radios with ISO connec-
tor (7 607 893 093/ 7 607 855 094).
Applications and loudspeaker con-
nection
Stereo-Mode
Max Power
Fig. 4, 5
Mono-Mode
Max Power
Fig. 6
Stereo-Mode
Max Power
Fig. 4, 5
Stereo-Mode
RMS Power
Fig. 4, 5
Mono-Mode
RMS Power
Fig. 6
Stereo-Mode
RMS Power
Fig. 4, 5
Frequency response
8
2 x 110 Watt / 4 Ω
1 x 375 Watt / 4 Ω
2 x 170 Watt / 2 Ω
2 x 55 Watt / 4 Ω
1 x 170 Watt / 4 Ω
2 x 85 Watt / 2 Ω
10 Hz - 26.000 Hz
Signal-to-noise ratio
Distortion factor
Stability
Input-sensitivity
Low-pass filter
High-pass filter
Bass Boost
Dimensions
W x H x D (mm)
Positive/negative connection
We recommend a cable cross-section of not
less than 6 mm 2 . Run a standard commer-
cial positive cable to the battery and con-
nect to the fuse holder. Use cable grommets
when passing cables through holes with
sharp edges. Bolt a standard commercial
negative cable to a ground point free of in-
duced noise (car body bolt, body panel) -
not to the negative battery pole. Clean the
contact surface of the ground point down to
bare metal and coat with antiseize graphite
petroleum.
Integral fuses
The integral fuses within the amplifier pro-
tect the final stage and the entire electrical
system in the event of a fault. Never bridge
fuses or replace fuses with a higher current
rating.
Example connections
Power supply connection
Connection of car radio
with cinch output
Loudspeaker connections
> 90 dB
(RMS) < 0,05%
2 Ω
0,1 - 8 V
50-250 Hz
80 Hz
0-12 dB
190 x 56,5 x 260
fig. 2
fig. 3
fig. 4/5/6