Using The Side Burner; Lighting Instructions - Fisher & Paykel DCS BFGC-30 Guide D'installation / Guide D'utilisation

USING THE SIDE BURNER

LIGHTING INSTRUCTIONS

First remove the cover and any cooking utensils from the burner grate. Check to see if the burner cap is on cor-
rect. Push, turn and hold the control knob in at the "HI" position until the burner is lit or 4 seconds pass
(Fig. 55). If the burner doesn't ignite, wait 5 minutes for any accumulated gas to dissipate then try again. If the
burner will not light after several attempts, check the troubleshooting instructions on page 36.
MATCH LIGHTING
Hold a paper book match near the burner ports, turn the control knob counterclockwise to "HI". Rotate the knob
immediately once the burner is lit to the desired setting.
Note:
If you are using propane gas, a slight pop or flash may occur at the burner ports a few seconds after the burner has been
turned "off". This "extinction pop" is normal for propane gas.
Control
Knob
29
Fig. 55
EN