Publicité
Les langues disponibles
Les langues disponibles
TIMER
The timer function is only used to count the time and does not infl uence oven opera-
tion or any programmes which are in progress or set.
1.
Press
- "0:00" appears on the programmer display.
2.
Press
or
to set the time required (or turn the temperature dial to the right
to increase the time and to the left to reduce it) - the bell symbol lights up on the
display.
3.
The countdown starts immediately and the time appears again.
4.
To see the countdown press
the seconds are only indicated for the last minute.
5.
At the end of the countdown an audible signal sounds and the bell symbol goes
out. Press any button to stop the audible signal.
IMPORTANT WARNING: This function is only an electronic alarm and does not
switch OFF the oven. Remember to turn to
lector dial at the end of the countdown.
AUTOMATIC COOKING -
switch the oven off automatically after the programmed cooking time
OR SEMI-AUTOMATIC COOKING -
switch the oven off automatically after the programmed cooking time
Setting
1.
Set the cooking function by turning the oven selector to the function required.
2.
The pre-set cooking temperature appears on the display. To change it proceed
as described in the "USING THE OVEN" chapter.
3.
Press
of the programmer to confi rm the cooking function.
4.
Press
: "0:00" appears on the electronic programmer display.
Press
or
to set the cooking time or turn the temperature dial to the right
to increase the time and to the left to reduce it (cooking time in hours and minu-
tes: set it to ten minutes less than the time required because the stored heat will
complete the cooking). "A" appears on the display.
5.
Press
; then press
or turn the temperature dial to the right to increase the time and to the left to
reduce it.
6.
The display reads the set temperature.
Semi-automatic cooking: If you are already at home to turn the oven on and
only want the oven to turn off automatically, start cooking as normal, then fol-
low step 4 or step 5 to set the cooking time or a time to stop the oven.
Starting cooking
7.
The cooking symbol
set starts.
During cooking
8.
During the cooking cycle, the display shows the oven temperature measured by
the probe or pre-set temperature. Press
Press
to display the stop time set. The cooking time, end of cooking time and
cooking temperature can be varied at any time, as described above.
At the end of cooking
9.
"End" appears on the display, "A" fl ashes and the audible signal sounds. The
cooking cycle has fi nished and the oven is OFF. Press any programmer button
to stop the audible signal.
10. Turn the function selector to
the time.
Note: At the end of the program always turn the function selector dial to
(oven OFF).
IMPORTANT: During AUTOMATIC COOKING PROGRAM the oven light is always
on, also before starting (heating elements on or cycling) of the programmed
cooking.
. The time will be indicated in hours and minutes;
OFF
(oven OFF) manually the se-
Start cooking at the programmed time and
Start immediate cooking and
or
to set the time when the cooking should fi nish
lights up. The oven switches on and the cooking cycle
to display the length of cooking set.
OFF
(oven OFF). The programmer display shows
1
2
3
4
5
OFF
9
5
A
OFF
A
OFF
A
A
OFF
A
OFF
A
29
29
Publicité
