Fisher & Paykel OR30SDPWGX Guide D'utilisation page 24

4
A
1
A
2
A
OFF
24 24
HOW TO STOP THE SELF CLEANING CYCLE
1. Turn the function selector to
If the oven cavity temperature is higher than 570°F (300°C):
•
•
If the oven cavity temperature is lower than 570°F (300°C):
•
•
IMPORTANT: Wait for the oven to cool down completely before starting a coo-
king function.
2. ACCIDENTAL INTERRUPTION OF THE SELF CLEANING CYCLE.
The function selector has been turned to any cooking function.
If the oven cavity temperature is higher than 570°F (300°C):
•
•
•
If the oven cavity temperature is lower than 570°F (300°C)
•
•
•
IMPORTANT: Wait for the oven to cool down completely before starting a
cooking function.
WHAT TO DO WHEN THE SELF CLEANING CYCLE HAS FINISHED
1. "P0:00" and "A" appear on the programmer display ("P" and "A" fl ashing)
Wait for the oven to cool down and the door to unlock.
The self cleaning cycle has fi nished. The door remains locked until the cavity
temperature has dropped below 570°F (300°C).
2. The door locked light goes out (when the temperature has dropped below 570°F
- 300°C). The door is unlocked and can be opened.
3. Turn the function selector dial to
The time appears on the programmer display.
4. Wait for the oven to cool down completely.
5. Remove the ash.
3 Open the oven door and remove the residue of ash inside the oven with a damp
cloth.
IMPORTANT: Let the appliance cool down completely before switching the
oven on again.
A
OFF
"Hot" appears on the programmer display.
When the oven cavity temperature drops below 570°F (300°C):
– the door locked pilot light goes out;
– the door unlocks and can be opened;
– the time of day appears on the programmer display.
The time of day appears on the programmer display.
After a technical time:
– the door locked pilot light goes out;
– the door unlocks and can be opened.
"Hot" appears on the programmer display.
When the oven cavity temperature drops below 570°F (300°C):
– the door locked pilot light goes out;
– the door unlocks and can be opened;
– pre-set temperature of the selected function fl ashes on the programmer
display.
To reset normal conditions turn the function selector to
Pre-set temperature of the selected function fl ashes on the programmer display.
After a technical time:
– the door locked pilot light goes out;
– the door unlocks and can be opened.
To reset normal conditions turn the function selector to
The time appears on the programmer display.
(oven OFF).
OFF
(oven OFF).
OFF
(oven OFF).
OFF
(oven OFF).