Télécharger Imprimer la page

Fisher & Paykel OR30SDPWGX Guide D'utilisation page 22

Publicité

Les langues disponibles

Les langues disponibles

4
2
A
3
A
A
4
22
22
HOW TO START THE SELF CLEANING CYCLE
Important: The self cleaning cycle must only be performed with the oven empty;
so, before starting the cycle take all the accessories (shelves, drip tray, ...) out
of the oven cavity and dry any traces of overfl owed liquid.
Do not use any de-greasing products (e.g. de-greasing sprays, detergents, etc.).
1.
2.
3.
4.
A
OFF
The self cleaning cycle starts immediately (the symbol
pleted in the programmed time.Throughout the self cleaning cycle the programmer
displays the time (hours and minutes) remaining until the cycle is fi nished.
VERY IMPORTANT:
The self cleaning cycle only starts with the oven door closed. If the door is
open or not closed properly ("door" fl ashes on the display) the oven CANNOT
perform the self cleaning cycle; electronic safety devices prevent the self cle-
aning cycle from starting.
Close the oven door (if it is open or not closed properly, "door" fl ashing on the
display, the self cleaning cycle will not start).
Turn the oven selector dial to the self cleaning position
cleaning time, 1 hour and 30 minutes) appears on the electronic programmer
display with the letter "P" fl ashing.
To increase the self cleaning cycle time (max 3 hours) press
grammer then
. To go backwards to the minimum of 1 hour and 30 minutes
press
then
. Alternatively press
the temperature dial to the right to increase the time or to the left to reduce it.
During the setting "P" is not shown on the display.
Press
on the programmer to start the cycle.
This combined confi rmation operation offers greater safety when there are
children; in fact turning the dial to the self cleaning function has no effect if
of the programmer is not then pressed.
The programmer display reads PH:MM (H:MM=self cleaning time where H=hours
and MM=minutes) and the door is locked after some seconds.
On the control panel the door locked pilot light lights up to indicate that the door
is locked.
; "P1:30" (self
of the pro-
of the programmer and then turn
lights up) and is com-

Publicité

loading

Ce manuel est également adapté pour:

Or30sdpwg