Fisher & Paykel E522B Instructions D'installation Et Guide De L'utilisateur page 45

Problem
Water has poor
taste/odor.
Water dispenser
does not work
and/or icon
flashing.
Water in first glass
is warm.
Filter warning light
is flashing.
Measured Fill
amount of water is
inaccurate.
Drips overflow
drip-shelf.
Water flow rate has
slowed down.
Possible causes
Refrigerator not used for an
extended period.
Water supply turned off or not
connected.
Supply line may be blocked.
On first installation there may be
air in water system.
Filter may be blocked and need
replacing.
Dispenser lock activated.
Water frozen in tank.
Water dispenser not used for
extended period.
Tank capacity used recently.
Filter needs replacing.
Measured Fill needs
recalibration.
Air trapped in tank.
New filter installed.
Filter cartridge is restricted.
Troubleshooting
What to do
Dispense 10 qt (10 L) water so fresh
water supply is replenished.
Turn water on.
Press dispenser for 1 minute to remove
trapped air from water line and to fill
the water system.
Check supply for kinks or leaks.
To remove air, run a liter or a quart of
water through the dispenser.
Replace filter (see back of this booklet
for Customer Care contact details).
Hold down the and
seconds.
Increase temperature to a warmer
setting in fresh food compartment and
freezer.
Discard first glass of water dispensed.
Allow water time to cool.
Replace filter as soon as possible (refer
to pages 28 – 29).
Recalibrate (refer to page 30).
Flush 3 qt (3 L) water through
dispenser, stopping intermittently.
Flush 3 qt (3 L) water through filter and
then 3 qt (3 L) through dispenser.
Replace water filter as soon as possible
(refer to pages 28-29).
43
EN
button for 2