Mendip Stoves Loxton 5 Manuel De L'utilisateur Et Mode D'emploi page 13

AIR CONTROL
Primary air slide to left
closed
Out =open /In closed
Your stoves parts
Always use the operating tools provided when handling parts likely to be hot when the stove is in use. The Loxton
,Churchill & Sqabox stoves have the following tools and parts packed in the stove
1) Cast Iron grate & log retainer
2) Ash tray removal tool
3) Stove Glove
4) Instruction manual
5) Warranty card
5) Ash Pan
Maintenance
Mendip stoves recommends that the Churchill, Loxton & Sqabox models need to have the ash removed from the stove at
regular intervals (weekly if used daily). Allowing the ash pan to over flow can impede the function of the stove and can
cause possible damage to the stove grate and ash pan. To remove ash pan use ash pan tool to hook under frontal loop on
front of ash pan drawer. Lift and pull out of firebox chamber. Take care to support ash pan during movement, always
wear a heat resistant glove. Make sure the stove is completely cold before cleaning out ash (embers can remain hot for
over 24 hours).
Ash must be stored in a non-combustible container and must not be mixed with other combustible waste.
Prolonged non use (summer)
If the stove is to be left unused for a prolonged period of time (e.g. over the summer) then it should be given a thorough
clean to remove ash and unburned fuel residues. To enable a good flow of air through the appliance to reduce
condensation and subsequent damage, leave the air controls fully open.
It is important that the flue connection, any appliance baffles or throat plates and the chimney are swept prior to lighting up
after a prolonged shutdown period.
Annual service
The inside of the stove should be serviced /cleaned once a year. To clean the inside, remove all ash, soot and tar residue
from the combustion chamber. Remove insulated chamber panels and baffle, dirt and soot will collect behind it and this
must be cleaned out. Check the quality of all insulated panels and replace any which are damaged or cracked, replace
stove door rope cord in the door. Check glass is correctly positioned.
The stove, the flue pipe connection and the chimney should be checked regularly by a qualified engineer. The chimney
should also be checked for blockages before relighting the stove if it has not been used for an extended period of time.
The paint/ lacquer can wear thin in exposed places due to overheating. This, and other lacquer damage, may be repaired
using Senotherm paint/lacquer spray available from your Mendip dealer. To clean the outside of the stove use a dry
cloth.
Tertiary air
Permanently open
Secondary air slide to right
Out =open /In closed closed
To Open door
lift handle.
To close push
door closed
and push
13
When opening the door
of your Mendip stove
always wear the glove
that is provided to
protect your hand from
possible heat.
The handle has push pull
motion as shown above.
When shutting the door
push the door closed and