When An Error Message Is Displayed During Measurement; When A Warning Message Is Displayed After Measurement - Yamaha RX-V765 Mode D'emploi

When an error message is displayed
during measurement
Press kCursor n once, and select "Retry" or
"Exit" using kCursor l / h and then press
kENTER.
ERROR
.
E-9:USER CANCEL
Don't operate
any function
>Retry
p [
[ ]/[ ]:Select
[ENTER]:Return
Retry
Performs the automatic setup procedure again.
Exit
Terminates the measurement and the automatic setup
procedure.
y
• See page 66 for details on error messages.
• When "E-5:NOISY" appears, you can continue measurement. To
continue measurement, select "Proceed." However, we recommend that
you solve the problem first and then perform measurement again.
Exit
Optimizing the speaker setting for your listening room (YPAO)
When a warning message is displayed
after measurement
If a problem occurs during measurement, "WARNING" is
displayed on the result display screen. Check the error and
solve the problems.
WARNING
W-1:OUT OF PHASE
Reverse channel
FL
CENTER
---
SL
SBL
p [
[ ]/[ ]:Select
[ENTER]:Return
y
• See page 67 for details on warning messages.
• Optimization will not be performed while a warning message is
displayed. We recommend that you solve the problem and perform the
automatic setup procedure again.
1
If "→" is displayed on the left of "WARNING"
on the result display screen, press
kENTER.
Details of the warning message are displayed. If there
are multiple warning messages, you can display the
next message using kCursor h.
2
To return to the top result display, press
kENTER again.
---
---
---
---
23
En