Installation Instructions - NEC MultiSync 20WMGX2 Manuel De L'utilisateur

Installation Instructions

To attach the MultiSync
1. Turn off the power to your computer.
Choose the appropriate cable type. (Figure 1)
2. For the PC or MAC with DVI digital output: Connect the DVI signal cable to the connector of the
display card in your system (Figure 2). Tighten all screws.
For the PC with Analog output: Connect the 15-pin mini D-SUB signal cable to the connector of the
display card in your system (Figure 3). Tighten all screws.
For MAC setup: Connect the Macintosh cable adapter to the computer, then attach the
15-pin mini D-SUB signal cable to the Macintosh cable adapter (Figure 4). Tighten all screws.
NOTE: To obtain the MultiSync Macintosh cable adapter, call
NEC Display Solutions of America, Inc. at (800) 632-4662.
Audio input
from PC
DVI
Connector
Figure 3
NOTE: PREVENTION OF SCREEN BURN
Continuous on-screen display of fixed (non-moving) images, such as video games, stock market quotations, computer
generated graphics and other patterns can cause permanent damage to the LCD MONITOR.
Such "SCREEN BURN-IN" constitutes misuse and IS NOT COVERED by our Factory Warranty.
LCD monitor to your computer, follow these instructions:
®
Figure 1
USB
Connector
15 Pin mini D-sub
VGA Connector
DVI Signal Cable
Macintosh Cable Adapter (not included)
Note: Some Macintosh systems do not require
a Macintosh Cable Adapter.

Figure 2
Figure 4