NEC MultiSync 20WMGX2 Manuel De L'utilisateur page 8

Component Names and Functions
ADVANCED DV MODE
PROGRAM / ADJUST (t)
DYNAMIC VIDEO MODE
Installing the Batteries
1. Open the battery cover.
Slide back and remove the battery
cover in the direction of the arrow.
2. Installing the batteries.
Install two included Size AAA
batteries.
Align according to the (+,-).
3. Close the battery cover.
Replace the battery cover in
the direction of the arrow and
snap it back into place.
CAUTION
• Do not mix new and old batteries together. The batteries could
explode or leak, resulting in fires, physical injury, or stains.
• When inserting batteries, observe their correct polarities as marked
on the product. If inserted in the wrong direction, the batteries could
explode or leak, resulting in fires, physical injury, or stains.
TV TUNER
NUMBER
KEYPAD
CHANNEL LOCK
LAST CHANNEL
MENU
ENTER
ASPECT
SLEEP
PIP ON / OFF
PIP INPUT
PC1
PC2
VIDEO 1
continued
LED INDICATOR
POWER ON / OFF
VOLUME UP / DOWN (pq)
CHANNEL UP / DOWN (pq)
CLOSED CAPTION DISPLAY
DISPLAY
PROGRAM / ADJUST (u)
STILL
MTS
MUTE
AUDIO
PIP SWAP
VIDEO 2
Using the Remote Control
Point the remote control toward the sensor on the front
of the monitor when pressing buttons.
Use the remote control within about 16 feet from the
front of the unit's remote control sensor and within 30
degrees on both sides.
ATTENTION
• Do not drop the remote control.
• To avoid possible failures, do not splash the remote control with
water or put it on a wet object.
• If leaving the remote control out of use for an extended period of
time, remove the batteries from it.
• If the remote control does not respond properly, replace the
batteries.
• Strong light such as direct sunlight exposed on the photoreceptor of
the remote control can cause operational failure. Position this unit to
avoid direct contact with such light.