Hilti DD100-B Mode D'emploi page 25

DD100 motor
➀
➂
➁
➀
Quick-change coupling for rapid re-equipping with different chucks
➁
Adjustable side handle
➂
3 speeds
➃
Overload indicator
➄
Switch with infinite speed adjustment (for hole-starting mode)
Caution:
Switch should be fully depressed when DD 100 is in continuous operation!
Please refer to the respective regulations of your trade association and the enclosed safety pre-
cautions.
Before beginning work: Please observe the enclosed safety precautions!
Please keep these operating instructions in a safe place.
Printed: 07.07.2013 | Doc-Nr: PUB / 5069505 / 000 / 00
Technical data
Voltages:
Power input:
Current input:
➄
Frequency:
➃
No-load speed:
Drill bit size range
Wet drilling, hand-held:
Wet drilling with drilling rig:
Dry drilling:
Drilling depth
Wet:
Dry:
Drilling rig stroke:
Weight (basic unit without cord):
Dimensions (unit without head):
Chuck for core bits :
Depth gauge:
Electronic speed regulator for constant no-load speed (nominal speed)
Overload current regulator and integrated starting current regulator
Thermal/mechanical motor protection/safety clutch
Electrical protection class1 (electric supply with earth/ground connection necessary)
Radio and television interference suppression in accordance with EN 55014-1
Ground fault interruptor (PRCD)
Zero-voltage trip
Right of technical modifications reserved!
100/110 V 230/240 V
100V = 1400 W 1700 W
110 V = 1600 W
15 A 8 A
50/60 Hz 50/60 Hz
1 st speed: 1200 r.p.m.
2 nd speed: 2400 r.p.m.
3 rd speed : 3900 r.p.m.
(Operate speed-change switch only
when motor has stopped.)
8– 42 mm dia.
8– 87 mm dia.
16–162 mm dia.
Approx. 280 mm
Up to 400 mm (above 25 mm dia.)
Up to approx. 330 mm
6,2 kg
440×115×155 mm
Hilti quick-change DD-BI
(Key-type chuck)
Same as TE machines
6 mA 10 mA
25