Installation Instructions; Installation; Anti-Tumble Measures - Yamaha PDM-4220 Manuel Utilisateur

INSTALLATION INSTRUCTIONS

Installation

WARNING
Use one of the special mount units to install this product. A mount of insufficient strength or inadequate design can cause overturning or
dropping and result in fire, electrical shock or injury. Please note that our company assumes absolutely no responsibility for personal
injuries or property damage caused by use of other mount units or improper installation.
CAUTION
• In order to prevent an internal temperature increase, maintain a space of 10cm (4 inches :
For a desktop set-up) or more between the sides and other objects such as walls, etc.,
so that the ventilation holes are not blocked.(*)

Anti-tumble measures

CAUTION
Have this unit mounted in a stable place. Take measures to prevent it from tumbling down to avoid possible physical injury.
Securing to a wall or pillar
Use a commercially available cord, chain and clamp, secure the set to a firm wall or pillar.
Securing desktop
1) Using wood screws (two), fasten the set to the clamping screw holes on the rear of the
stand as shown.
2) Using commercially available wood screws, secure the set firmly in position.
Read CAUTION (
steps:
• Choose an appropriate site and install the product on a level table where the stand is secure.
• Install the monitor to have ready access to a power socket available.
• Make sure that the power switch of this device is turned off.
12
to ) carefully to ensure maximum safety before proceeding to these
3 7
10cm (4 inches) or more
Clamp
Cord
or
chain
Hook
Chain
clamp
Wood screw
Two places
*
cord or chain
Wall or Pillar