ergoline Ambition 250 VHP 15 Instructions D'utilisation page 50

Presets
System is now in Parameter Mode. To edit the parameters, be sure to
use the above instructions and use the level 2 (EDIT) password 0102 ins-
tead of the level 1 (0010). Keep all passwords in a safe place to prevent
misuse.
Note:
Parameters 6 and 32 are only editable at password level 1.
– Now press once to go to Parameter 02 (P02).
Note:
To reach the desired parameter press
past a parameter you may press
red parameter. Each time a button is pressed the timer will
display PXX (XX represents numbers) representing the pa-
rameter reached.
In View mode (leve 1) the display will show alternately the
number and the value of the current parameter.
P02 – Alarm Enable/Disable Function
Parameter 2 is the chime mechanism that provides an audible 'beep'
sound when the keys are pressed and to indicate the various operations
occuring. The audible beep can be enabled or disabled.
When parameter 02 is shown, the display will read 0001, the alarm is
enabled.
– Press to go to P03 without changing the setting.
50
To disable the alarm:
– Press Reset once and then release it. The display will begin to flash.
– Press
– Now press Reset once again.
The chime is now deactivated. To reactivate the chime, change para-
meter 02 back to 0001 using the instructions provided above.
– Press
P03 – Fan Delay
button. If you go
The fan delay maintains proper cooling of the tanning unit by continuing
to return to the desi-
to provide power to the cooling fans for a programmable amount of time
after the end of a tanning session.
When parameter 03 is shown, the display will read 1.0 representing one
(1) minute fan delay.
– Press
To change the fan delay:
– Press Reset once and then release it. The display will begin to flash.
– Press
Time is displayed from 1.0 to 5.0, with decimal representing tenths of
a minute. For example: 1.5 equals 1 minute, 30 seconds.
– Press Reset once then release it.
The fan delay is now set.
– Press
and hold it down, scrolling down to 0000.
to go to Parameter 03 (P03).
to go to P04 without changing the setting.
or to reach the desired setting.
to go to Parameter 04 (P04).