Putting Into Operation And; Putting Into Operation; Checking Proper; Terminating The System's Operation - Inventum Modesto Manuel D'utilisation

ENGLISH
11

Putting into operation and

terminating the system's
operation

11.1 Putting into operation

• Check whether the waterheater is comple-
tely filled with water and the installation is
free from leaks;
• Switch on the electricity to the device.
After being installed and filled with
the water, the waterheater must be
put into operation within three
months in order to guarantee pro-
per functioning.
11.2 Checking proper operation
After the device has been put into operation, you
must check the following points:
- Expansion water trickling from the relief
valve or pressureless mixing tap. This is
necessary in order to prevent the pressure
from getting too high in the waterheater
during the heating process;
- The entire system for leakage, also 30
minutes after having been put into operation.

11.3 Terminating the system's operation

• Switch off the electricity to the device. The
main cock of the water main can remain open.
11.4 Emptying the waterheater
• Disconnect the power plug from the wall
socket;
• Close off the main cock of the water main;
• Close off the stop cock of the inlet combination;
• Open a hot water tap;
• Collect any leak water.
• Disconnect the water connections to the
waterheater at the inlet combination and
at the hot-water tap;
• Place the waterheater horizontal, with the
cold-water hose in the sink and the hot-
water hose facing upward. The waterheater
siphons itself automatically empty.
Fig. 6 Placing Slide-In waterheater behind the baseboard
Attention: Follow the directives for correct placing of the
adjustable legs of the kitchen cabinet. Set the thermostat with
care before replacing the baseboard.
The power supply cable must always be fed through a
recess in the bottom of the cupboard. When starting up
ensure that the power plug is in an easy to reach wall socket.
Fig.10 Course of pipes
Fig. 7 Placing Slide-In waterheater flat in the kitchen cabinet
It is advisable to place a shelf on top of the waterheater for
instance to put things on top of it. The temperature knob stays
reachable.
Fig. 8 Placing the slide-in waterheater vertically on the left or
right side of the kitchen cabinet this being dependent on
the position of the siphon.
Fig. 9 Placing the slide-in waterheater against the back of
the kitchen cabinet.
You could consider placing the slide-in waterheater behind the kit-
chen (in the installation space)
Fig.11 Correct vertical placing
Modesto/Modesto Hotfill
The Inventum name and logo are readable
en-7
11007