Treating The Upper Lip; Treating The Cheeks And Jaw; Treating The Neck And Chin; Care After Facial Treatment - Beurer IPL 10000+ Mode D'emploi

4. Follow the instructions for use (see previous chapter 8.1 "Starting treatment") and observe the follow-
ing specific instructions, in particular.
Note
Facial hair can be a result of hormones, which means that several sessions may be required to achieve
permanent hair reduction.

8.3 Treating the upper lip

Position the treatment window of the applicator as shown in the figure. Trigger a pulse in
every marked zone.
Avoid applying the treatment to the nostrils and lips, as these areas are more sensitive.
Note
You can "fold in" your lips or press them together to make the treatment area more taut, or apply a
thick layer of white eyeliner to the lips and around the edge of the lips. The white line ensures that the
energy of the flash is reflected and does not reach your lips, should you accidentally apply a pulse to
your lip.

8.4 Treating the cheeks and jaw

Position the treatment window of the applicator as shown in the figure. At each point, trig-
ger a pulse and move from one side of the check or jaw to the other.

8.5 Treating the neck and chin

Position the treatment window of the applicator as shown in the figure. At each point, trig-
ger a pulse and move from one side of the neck or chin to the other.
Note
The skin on the lower third of the neck is more sensitive. For this reason, avoid overlapping treatment
areas.

8.6 Care after facial treatment

• Apply a soothing lotion such as aloe vera.
• Do not use exfoliators, whitening lotions or similar products for at least 24 hours, as this could irritate
the treated skin.
• For at least 48 hours after the treatment, avoid more than 15 minutes of direct exposure to the sun. If
recently treated skin is exposed to sunlight during this period, sun protection with SPF 30 or higher
must be applied.
• Do not remove hair on the treated areas using wax or tweezers.
Remember that it may take a complete hair growth cycle for hair removal to be complete.

9. Care and maintenance of the beurer SalonPro System

9.1 Cleaning the beurer SalonPro System

After each hair removal session, it is recommended that you clean your beurer SalonPro System, paying
particular attention to the light area.
39